Maytag Dryer MLG23PDFXW Parts

Dryer drum support roller kit. Includes two washers. When the drum rollers are worn out, they can cause the dryer to make a loud rumbling noise. Both rollers should be replaced at the same time. The roller does not need lubrication, the bearing is self-lubricating.

Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.

Snap retaining ring

Dryer drum drive belt

Idler pulley wheel and bearing. If the idler pulley wheel and/or bearing is defective, it may cause the dryer to be excessively noisy.

Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.

Dryer igniter with wire harness connecter. This is a flat-style igniter. The igniter uses heat to ignite the gas in the burner assembly. If the igniter is defective, the gas will not ignite and the dryer will not heat.

Adjustable leveling leg for washing machine. This leveling leg has a rubber foot. If the leveling leg is not adjusted properly, the washer will be off-balance and will vibrate or shake during operation.

Drum baffle, tall

Screw, 10-24 3/8

Drum felt seal

Three terminal door switch kit. Be aware that this switch replaces older 2 terminal switches.

Leveling leg for pedestal

Drum baffle, short

Door catch kit, includes catch and clip (metal) Replace both parts for best results