Montgomery Wards Dryer LNC7445A77 Parts

Dryer drum drive belt. This belt is approximately 1/4" wide x 92-1/4" long. It is flat on one side and has 4 ribs and 3 grooves on the other. It replaces many other belts, including some with 5 ribs and 4 grooves. The belt attaches to the motor pulley and spins the drum as the motor rotates

Dryer thermal fuse and high limit thermostat kit for both gas and electric models. If the dryer does not heat then the thermal fuse may have blown and will need to be replaced.

Door catch kit, includes catch and clip (metal) Replace both parts for best results

Heating element assembly with replacement high limit thermostat, L248-80 (240 Volt, 4750 Watt). Dryer Heating element. If the dryer does not heat check for a blown thermal fuse or thermal cut out. Heating elements will often have a break in the coil element if defective.

Dryer drum drive motor assembly. If the dryer does not start the motor could be bad. Before replacing the motor the door switch and thermal fuse should be tested to determine if they are defective.

Drum glide kit, right side. *Pad has adhesive backing

High limit thermostat, L248-80F

Control thermostat, L146-25F, 240 Volt internal heater

Idler pulley wheel

Front glide kit, (1) right (1) left glide (2) pads with adhesive backing. Instructions included.

Belt idler rod and wheel assembly

Dryer timer.NOTE: This part is often misdiagnosed and requires electrical testing with a volt/ohm meter to determine if it is defective. *Please call with model and serial number to verify correct part.

Cycling thermostat, L146-25, 2 wire with extra terminal

Resistor assembly, timer

Knob and skirt assembly, white