Montgomery Wards Dryer LNC8440A/NO.REV Parts

Dryer drum drive belt. This belt is approximately 1/4" wide x 92-1/4" long. It is flat on one side and has 4 ribs and 3 grooves on the other. It replaces many other belts, including some with 5 ribs and 4 grooves. The belt attaches to the motor pulley and spins the drum as the motor rotates

Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.

Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.

Dryer thermal fuse and high limit thermostat kit for both gas and electric models. If the dryer does not heat then the thermal fuse may have blown and will need to be replaced.

Dryer lint filter (lint trap). Your lint filter should be replaced if it is torn or damaged in any way.

Door catch kit, includes catch and clip (metal) Replace both parts for best results

Door Seal - Dryer.

Gas line. 4' stainless gas dryer connector, (1) 3/8" and (1) 1/2" fitting, (1) extra 3/4" fitting, pipe thread sealant, leak test solution, and installation instructions.

The Whirlpool Burner Igniter WP31001556 is a high-quality replacement part for dryers that lights the gas burner to heat the dryer during the cycle. It replaces several other part numbers. Disconnect the appliance from all utilities prior to installation.

Leveling Leg

Cycling thermostat, L146-25, 2 wire with extra terminal

Idler arm & wheel assembly

Seal assembly, cylinder front

Resistor assembly, timer

Gas valve