Whirlpool Dryer LDI5751W1 Parts

Dryer drum drive belt. This belt is approximately 1/4" wide x 92-1/4" long. It is flat on one side and has 4 ribs and 3 grooves on the other. It replaces many other belts, including some with 5 ribs and 4 grooves. The belt attaches to the motor pulley and spins the drum as the motor rotates

Dryer drum drive motor with pulley

Dryer blower wheel. Used on 29 inch Whirlpool built models with lint filter on top. To remove the blower wheel, unscrew the blower wheel clockwise off the motor shaft.

Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.

Dryer thermal fuse (or thermal limiter). This fuse is located on the exhaust duct. If the dryer overheats, the thermal fuse opens to cut off power to the dryer. The thermal fuse cannot be reset--if the thermal fuse is open, it must be replaced.

Dryer lint screen assembly without handle

Dryer door/washer lid switch kit. Comes with dryer mounting bracket, (2) wire terminals and (2) mounting screws.

This is a genuine replacement part. Whirlpool 686711 Door Handle.

Adjustable dryer cycling thermostat kit L135-155. The cycling thermostat cycles the heat on and off to regulate the air temperature. If the cycling thermostat is defective, the dryer will not heat. To determine if the thermostat is defective, use a multimeter to test it for continuity.

Rear Drum Felt Seal with Adhesive.

This is a Genuine Replacement Part. Whirlpool (WHIRA) 279264 Bearing & Seal.

Motor retaining clamp

Right hinge for lint screen cover

Left hinge for lint screen cover

Dryer gas valve conversion kit from Natural gas to LP (liquid propane) & Butane.