Whirlpool Dryer YWED6200SW1 Parts

The Dryer Repair & Maintenance Kit 4392065 includes rollers, a belt, and an idler pulley. It is specifically designed for 29 wide dryers built in 1965 or later. This kit addresses common issues that cause Whirlpool, Kenmore, Maytag, and KitchenAid dryers to become noisy.

Dryer thermal fuse. Opens at approximately 196°F (91°C). *If open check for air flow issues like plugged exhaust vent or damaged blower wheel

Dryer electric heating element assembly

Dryer drum support roller. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.

Dryer thermistor. This thermistor should read approximately 11.9K Ohms of resistance at 70 degrees Fahrenheit (21’ Celsius). If the thermistor is defective, it may prolong or shorten the drying time or cause a fault code. A defective thermistor is not responsible for a dryer not heating.

Dryer blower wheel. Used on 29 inch Whirlpool built models with lint filter on top. To remove the blower wheel, unscrew the blower wheel clockwise off the motor shaft.

Whirlpool's replacement thermostat kit includes a thermal cut-off fuse, high-limit thermostat, and electrical connection hardware to ensure your clothes are perfectly dry. Keep up with laundry by installing this genuine Whirlpool replacement part.

Plastic leveling leg. White approximately 1" round x 1 3/4" long

Dryer heating element wire connector kit. Wire with spade terminal & wire nut

Motor pulley, 60 hertz

Dryer tri-ring retainer for drum support rollers.

Light Bulb 10 Watt small base

Dryer door catch. If the dryer door does not latch closed then the door strike or this catch is likely damaged

White Touch Up Paint

Screw, 10-24 x 1/2