Price Match GuaranteeKenmore Dryer 110.77042600 Parts
Shop replacement repair parts for Kenmore Dryer model 110.77042600
Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.
Dryer thermistor. This thermistor should read approximately 11.9K Ohms of resistance at 70 degrees Fahrenheit (21’ Celsius). If the thermistor is defective, it may prolong or shorten the drying time or cause a fault code. A defective thermistor is not responsible for a dryer not heating.
Dryness sensor bar
High-limit thermostat kit. Contains hi limit thermostat and thermal cut out fuse. If the dryer overheats, the high-limit thermostat cuts off power to the dryer. If the dryer won't heat, the high-limit thermostat may have blown. This part has been updated by the manufacturer and may look different.
RC Item #1206293
Dryer lint filter. Air flow is vital to proper dryer operation. The lint filter should be cleaned before every load and replaced if damaged.
Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.
Dryer tri-ring retainer for drum support rollers.
Dryer door catch. If the dryer door does not latch closed then the door strike or this catch is likely damaged
Dryer idler wheel and bracket assembly. Provides tension to the dryer drum belt.
Dryer thermal fuse (or thermal limiter). This fuse is located on the exhaust duct. If the dryer overheats, the thermal fuse opens to cut off power to the dryer. The thermal fuse cannot be reset--if the thermal fuse is open, it must be replaced.
White Touch Up Paint
Shaft for dryer drum support roller. Rear shaft with left hand threads. Part is updated so nuts may need to be replaced as well on older dryers.
Dryer front panel retainer clip. 1 clip per pack.
Dryer LP conversion kit; Natural gas to LP (liquid propane). This kit includes the orifice, leak limiter, and instruction sheet.
Shaft for dryer drum support roller. Front shaft with right hand threads. Part is updated so nuts may need to be replaced as well on older dryers.
Frequently Purchased Together For This Model
Family-owned and operated since 1912, Burke America Parts Group is the longest-running genuine appliance, HVAC, and outdoor power equipment parts solution in North America. At Repair Clinic, we're proud to be an international brand trusted by the pros as well as the DIY community.
About Repair Clinic