GE Dryer TD-V10018E Parts

Drum Support Roller & Axle Set of 4 AGM75510755 set includes 4 drum rollers, the roller shaft, and mounting clips to ensure quiet operation. As the bearings wear, they self-lubricate, eliminating the need for additional grease. This set is compatible with various dryer models from LG and Kenmore.

Dryer drum drive belt. 1/4 inch wide with 4 ribs and 3 grooves. The drive belt is a very long, slender belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.

Dryer thermal fuse. If the dryer overheats, the thermal fuse blows to cut off power to the dryer. If the thermal fuse has blown, the dryer won't start. The thermal fuse cannot be reset—if the fuse has blown, replace it. Thermal fuses often blow due to a clogged vent.

Dryer moisture sensor bar. If the dryer timer does not advance properly inspect the moisture sensor bars for damage which can cause the automatic drying cycle to not work properly.

Felt seal, dryer drum

Idler pulley wheel with bearing

Blower wheel

Dryer heating element assembly. If the dryer no longer heats then the heating element may have failed, but it is not the most common cause. The most common cause for a dryer to stop heating is a blown thermal fuse.

Switch assembly, safety

Dryer drum drive motor with pulley. If the dryer does not start the motor could be bad. Before replacing the motor the door switch and thermal fuse should be tested to determine if they are defective.

Dryer high-limit thermostat. L257-88F, L125-31C. The high-limit thermostat cuts off power to the dryer if the dryer overheats. If the dryer won't heat, the high-limit thermostat may have blown.

Dryer discharge duct assembly

Micro switch assembly. Switch is two terminal Normally Closed

Bracket,motor

Pcb assembly,main