Price Match GuaranteeKenmore Dishwasher 630.16303400 Parts
Shop replacement repair parts for Kenmore Dishwasher model 630.16303400
The Bosch Door Seal 00494772 is a genuine OEM part that seals the gap between the dishwasher tub and the outer edge of the door. It is compatible with various dishwasher models and can be installed without tools.
Dishwasher drain pump. If the water does not drain from the dishwasher then the drain pump may be clogged, damaged, or defective. *You may need to order the related wire connector to install.
The Bosch Lower Door Seal 00432490 is a high-quality OEM part that seals the gap between the dishwasher door and tub. It includes mounting brackets and replaces several original part numbers. Safety precautions should be taken during installation. Compatible with various Bosch dishwasher models.
The Bosch Water Inlet Valve 00425458 is a high quality OEM part that supplies water to the dishwasher. It has a single water in-flow and out-flow port and is compatible with various Bosch, Kenmore, and Thermador dishwasher models. Safety precautions should be taken during installation.
The Bosch Tine Row Clip 00418498 is a high-quality OEM part used in the lower rack of a dishwasher to hold the tine row in place. It allows for the conversion of the rack to accommodate more dishes of different shapes and sizes.
RC Item #473645
The Bosch Drain Hose 00298564 is a genuine OEM part that carries drain water from the dishwasher to the kitchen sink drain. It is 5 ft. in length and comes with one O-ring. The hose is compatible with various Bosch dishwasher models and replaces several part numbers.
Dishwasher lower dishrack assembly with wheels. Corroded or rusted dishracks should be replaced to avoid parts of the rack falling down and getting into the circulation pump damaging the pump.
Hinge Bushing Snap Lock
The Bosch Dishrack Roller 00165314 is a genuine OEM part that attaches directly to the rack and allows the lower rack to roll in and out of the dishwasher with ease. Sold individually. Recommended to replace in pairs due to wear and tear. The roller has a diameter of approximately 1.5 inches.
Tine clip kit (also called a bearing) for dishwasher dishrack. Includes (2) bearings (2) sleeves and (4) tine clips.
The Bosch Check Valve 00165262 is a high-quality OEM part that prevents water from flowing back into the tub. It replaces several part numbers and is compatible with various dishwasher models. Safety precautions should be taken during installation. Sold individually.
Door support rope and pulley kit
The Bosch Float Switch 00165256 is an OEM part that shuts off the water fill valve if the water level gets too high before the fill cycle ends. Compatible with many Bosch, Gaggenau, Thermador, and Kenmore brand dishwashers. Replaces several part numbers. Take safety precautions during installation.
The Bosch Upper Dishrack Slide Rail Stop 00165254 is a high quality, genuine OEM part that prevents the upper dishrack from sliding completely off the slide rail. It includes front and rear rack stops and is compatible with various Bosch dishwasher models.
The Bosch Mounting Bracket Set 00170664 is a high quality OEM part that prevents the dishwasher from tilting forward. It includes 2 metal brackets and is compatible with various Bosch dishwasher models. Hardware is not included and safety precautions should be taken during installation.
Frequently Purchased Together For This Model
Family-owned and operated since 1912, Burke America Parts Group is the longest-running genuine appliance, HVAC, and outdoor power equipment parts solution in North America. At Repair Clinic, we're proud to be an international brand trusted by the pros as well as the DIY community.
About Repair Clinic