Maytag Dryer MEDC700VW0 Parts

Dryer thermal fuse. Opens at approximately 196°F (91°C). *If open check for air flow issues like plugged exhaust vent or damaged blower wheel

Dryer heating element assembly. If the dryer does not heat the thermal fuse should be checked before replacing the heating element. Normally, the element will have a break in the coil if defective.

Dryer idler pulley assembly. Includes bracket and pulley wheel

Dryer door switch assembly. If the dryer does not start then the door switch could be defective. This switch also replaces the two wire switch.

Dryer idler pulley wheel kit. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dryer will not spin

Dryer drum drive belt 92 1/2"

Heating element thermal cut-off (thermal fuse) 360 degrees and high-limit thermostat 250 degrees. The thermal fuse is a safety device designed to protect the dryer from overheating. A multimeter can be used to test the fuse. Always check the dryer venting when replacing a blown thermal fuse.

Drive motor kit - Note; the wiring connections may be different, comes with instructions

High-limit thermostat, 2 wire, 250 degree limit, 60 degree cool down before reset. The high-limit thermostat cuts off power to the dryer if it overheats. If the thermostat has tripped, the dryer will not heat. To determine if the thermostat is defective, use a multimeter to test it for continuity.

Dryer timer. The dryer timer will not advance if the dryer is not heating properly.

Push to start relay switch. NOTE: If the dryer will not start check the thermal fuse before ordering start switch. The switch is often not the cause of the dryer failing to start.

Knob

Knob

Panel-cntl

Panel