Whirlpool Refrigerator Ice Ejector Bar Replacement #627843

Print ContentSave Content

Skill Level

Total Parts Cost

$65.11

Estimated Savings

$112.50

04:12

Description

This video provides step-by-step instructions for replacing the ice ejector bar on Whirlpool refrigerators. The most common reason for replacing the ice ejector bar is when it does not properly dispense ice.

All of the information in this ice ejector bar replacement video is applicable to the following brands: Kenmore, Whirlpool, Amana, KitchenAid, Maytag, Magic Chef, Jenn Air, Admiral, Crosley, Roper

Tools used: small slotted screwdriver, multi-screwdriver

Step By Step Instructions

Print Instructions

As with any repair, you should unplug the power cord before beginning.

To replace the ice ejector bar in the icemaker first remove the ice bucket.

Now lift up the ice access door and pull off the icemaker cover

Remove the bottom screw securing the icemaker assembly mounting bracket.

Now loosen the top screws and lift the assembly off of the screws.

Be aware the ice tray will be filled with water or ice.

Next, release the thermal fuse from the retaining clip.

Depress the retaining tab to release the wire harness.

Remove the icemaker assembly from the freezer and set it on a sturdy surface.

Detach the ice level arm.

Now remove the screws securing the control module and pull the module off.

Next, remove the screws securing the control module housing to the mold.

Separate the housing from the mold.

Pull off the ice rake and lift out the old ice ejector bar if still intact.

Install the new ice ejector bar by inserting the short end into the fill cup.

Slide the ice rake into position and align the control module housing with the mold and slide it into place.

Align the control module with the housing and rotate the new ice ejector bar until the module can be fully seated.

Secure the module with the screws.

Reposition the ice level arm on the assembly and snap it into place.

Returning to the freezer compartment, snap the wire harness into place on the assembly and secure the thermal fuse under the retaining clip.

Align the fill cup with the water spout as you position the assembly on the screws.

Tighten the screws and replace the bottom screw to secure the assembly mounting bracket.

Snap the cover onto the icemaker and close the ice access door.

Replace the ice bucket by aligning it on the rails and sliding it into place.

If you have trouble positioning the bucket you can rotate the auger to fully seat the drive coupler.

You’re now ready to plug the power cord back in and confirm that the icemaker is working properly.

Description

Step-By-Step Instructions