Price Match Guarantee
In-stock parts ship the same day
365-Day Return Policy
Price Match GuaranteeGET PRO PRICING
Video & Articles: Appliance & Equipment RepairKenmore Top-Load Washer Power Cord Replacement #W10820044
Kenmore Top-Load Washer Power Cord Replacement #W10820044
Skill Level
Total Parts Cost
$80.94Estimated Savings
$112.5002:04
- Description
This video provides step-by-step repair instructions for replacing the power cord on a Kenmore Top-Load washing machine. The most common reason for replacing the cord is if the washer will not run at all.
All of the information for this power cord replacement video is applicable to the following brands:
Kenmore, Whirlpool
Tools used: Phillips-head screwdriver, flat-head screwdriver
All of the information for this power cord replacement video is applicable to the following brands:
Kenmore, Whirlpool
Tools used: Phillips-head screwdriver, flat-head screwdriver
Step By Step Instructions
1
Before you the procedure of replacing the washer power cord make sure the old power cord is unplugged.
2
Detach the two control panel end caps by pulling them off from the top.
3
Use a phillips-head screwdriver to unthread the two screws securing the control panel.
4
Lift up the control panel and disconnect the power cord wire connecter.
5
Depress the tab to release the cord retainer and you can fully remove the old cord.
6
Install the new power cord by feeding the connecter through the rear panel then snap the cord retainer into the panel.
7
Connect the wire connecter.
8
Lower the control panel and snap the retaining clips into the slots in the main top.
9
Rethread and tighten the screws to secure the control panel.
10
Realign the end caps and snap them into place.
11
With the repair completed plug the new power cord in and your washer should be ready for use.
Description
This video provides step-by-step repair instructions for replacing the power cord on a Kenmore Top-Load washing machine. The most common reason for replacing the cord is if the washer will not run at all.
All of the information for this power cord replacement video is applicable to the following brands:
Kenmore, Whirlpool
Tools used: Phillips-head screwdriver, flat-head screwdriver
All of the information for this power cord replacement video is applicable to the following brands:
Kenmore, Whirlpool
Tools used: Phillips-head screwdriver, flat-head screwdriver
Step-By-Step Instructions
1
Before you the procedure of replacing the washer power cord make sure the old power cord is unplugged.
2
Detach the two control panel end caps by pulling them off from the top.
3
Use a phillips-head screwdriver to unthread the two screws securing the control panel.
4
Lift up the control panel and disconnect the power cord wire connecter.
5
Depress the tab to release the cord retainer and you can fully remove the old cord.
6
Install the new power cord by feeding the connecter through the rear panel then snap the cord retainer into the panel.
7
Connect the wire connecter.
8
Lower the control panel and snap the retaining clips into the slots in the main top.
9
Rethread and tighten the screws to secure the control panel.
10
Realign the end caps and snap them into place.
11
With the repair completed plug the new power cord in and your washer should be ready for use.
Applicable Product Model
Related Articles & Videos
Our Story
Family-owned and operated since 1912, Burke America Parts Group is the longest-running genuine appliance, HVAC, and outdoor power equipment parts solution in North America. At Repair Clinic, we're proud to be an international brand trusted by the pros as well as the DIY community.
About Repair Clinic
© 2026 RepairClinic.com