DescriptionThis video provides step-by-step repair instructions for replacing the convection fan cover on a Kitchenaid Double Wall Oven (model #KODE500ESS02). The most common reason for replacing the cover is if it is damaged or dirty.
All of the information for this cover replacement video is applicable to the following brands:
Kitchenaid, Whirlpool
Tools used: Phillips-head screwdriver, 1/4" socket or nut driver
Step-By-Step Instructions1
KitchenAid Built-In Double Oven - KODE500ESS02
2
Double Wall Oven Convection Fan Cover Replacement
3
Tools needed: Phillips-head screwdriver
5
Be sure to shut off the power to the oven junction box.
6
For easier access to the rear of the oven, we recommend removing the appropriate oven door.
7
Fully open the door and rotate both door hinge locks back.
9
Partially close the door, then lift and pull the door toward you to remove.
10
With the handle side down, set the door on a blanket.
11
Remove any racks that are in the way.
12
Using a Phillips-head screwdriver, unthread the two screws securing the convection fan cover.
14
Pull the old cover up to detach.
15
Install the new convection fan cover by inserting the tabs into the rear panel slots, then lift the cover up and thread the screws to secure.
16
Replace any oven racks.
17
Reinstall the oven door by inserting the door hinges into the hinge slots at a forty-five degree angle.
18
Lower the door to its fully open position, then rotate the hinge locks forward.
19
With the repair completed, turn the power supply back on and the double wall oven should be ready for use.