DescriptionThis video provides step-by-step instructions for replacing the dispenser-to-tub hose on Electrolux washing machine. The most common reason for replacing the dispenser-to-tub hose is when the washing machine won't drain.
All of the information in this dispenser-to-tub hose replacement video is applicable to the following brands: Electrolux
Tools used: Phillips-head screwdriver or Number two square drive bit, & a 7mm socket.
Step-By-Step Instructions1
Electrolux Front-Load Washer - Model EFLS627UTT
2
Front-Load Washer Dispenser-To-Tub Hose Replacement
3
Tools & Assistance Needed
4
"You will need a Philips-head screwdriver (or a number two square drive bit), a 7mm socket and clamps for this procedure, and you may need assistance."
5
Be sure to unplug the power cord.
7
Have an assistant help you to move the appliance away from the wall.
8
"Using a Philips-head screwdriver or a number two square drive bit, unthread the rear screws securing the top panel."
10
"Using a 7mm socket, loosen the two screw clamps securing the old hose to the dispenser and the outer tub."
11
Pull the old hose free.
12
Prepare the new dispenser-to-tub hose for installation by transferring the two screw clamps from the old hose to the new one.
13
"Using the alignment arrows, position the appropriate end on the tub port and the opposite end on the dispenser port."
14
Tighten the screw clamps.
15
Realign the top panel and secure it with the screws at the rear.
16
Move the appliance back against the wall and plug the power cord back in.
17
Congrats! Your front-load washer is ready for use.