DescriptionThis video provides step-by-step instructions for replacing the outer door panel on Electrolux dishwashers.
All of the information in this video is applicable to the following brands: Electrolux
Step-By-Step Instructions1
Electrolux Dishwasher - 24ID75SPS3A
2
Dishwasher Outer Door Panel Replacement
3
"Heavy, Sharp, Shock, Water"
5
Be sure to turn the power off to the appliance
6
You will need a phillips-head screwdriver
7
Open the dishwasher door and use the phillips-head screwdriver to unthread all of the screws holding the inner and outer door panels together
8
Note the length of each screw and its location on the inner door panel - remove the top middle right screw last
10
Slide the outer door panel up to detach
11
Lift off the control panel and fully remove the outer panel
12
Disconnect the wire connector from the door latch and rest the control panel on the floor
13
Set the old outer panel down
14
"Using the phillips-head screwdriver or a number 2 square drive bit, unthread the screw securing the handle"
16
Align the handle with the new outer door panel
17
Thread the two screws into the upper holes in the handle
18
Position the control panel and connect the wire connector to the latch
19
"Slide the outer panel onto the inner panel, making sure the lower tabs rest behind the hinges"
20
Replace all of the screws in the appropriate location starting with the long top middle right screw