Cub Cadet Chipper Shredder Screen Replacement (719-04070)

Print ContentSave Content

Skill Level

Total Parts Cost

$49.74

Estimated Savings

$112.50

07:34

Description

This video provides step-by-step instructions for replacing the shredder screen on a Cub Cadet Chipper Shredder. The most common reason to replace this part is if the shredder is not cutting properly.

All of the information in this video is applicable to the following brands: Cub Cadet

Step By Step Instructions

Print Instructions

Cub Cadet Chipper Shredder - 24A424M710

Chipper Shredder Shredder Screen Replacement

"Sharp, Spill, Hot, Heavy"

"You will need a half-inch wrench and socket, a 7/16th inch wrench and socket, needle-nose pliers, and a small flat-head screwdriver."

Use the half-inch wrench to unthread the nuts securing the hopper assembly support plate

Use the half-inch socket to unthread the six mounting nuts securing the hopper assembly

Tilt the hopper assembly back and lift up to fully detach the assembly from the bolts

Remover the shredder plate

Unthread the two retaining knob screws securing the bottom of the discharge chute

Use the 7/16th inch wrench to secure the mounting bolt and the 7/16th inch socket to fully unthread the nut

"Slide out the bolt, detach the chute, and remove the two spacers"

Use the needle-nose pliers to pull out the cotter pin and then the screen pin

"Use the half-inch socket, the small flat-head screwdriver, and the pliers to remove the upper mounting screws securing the outer flail housing"

"With the tow bar installed, tip the chipper shredder back and set a weight on the tow bar to hold it down"

"Using the half-inch wrench, remove the ten remaining nuts and bolts securing the outer housing to the inner housing"

Fully detach the outer flail housing and remove the old shredder screen

Position the mounting post in the hole in the inner flair housing and realing the outer housing

Thread and tighten the ten nuts and bolts to secure

Rethread the two upper mounting screws using the speed clips

Remove the weight and return the chipper shredder to its upright position

Slide the shredder screen pin through the impeller and screen and insert the cotter pin

Realign the discharge chute on the impeller housing and insert the spacers

Insert the mounting bolt then thread and tighten the nut

"Fully position the chute, then thread and tighten the retaining knob screws"

Realign the shredder plate on the impeller housing bolts

"Reinstall the hopper assembly by aligning the support plate on the two upper mounting bolts first, then rotate the assembly to align it on the impeller housing bolts"

Thread and tighten all eight mounting nuts to secure

Description

Step-By-Step Instructions