DescriptionThis video provides step-by-step repair instructions for replacing the turntable motor on a Frigidaire microwave oven (Model FPMO227NUFA). The most common reason for replacing this part is if the turntable will not spin.
All of the information for this video is applicable to the following brands:
Frigidaire
Step-By-Step Instructions1
Frigidaire Microwave Oven - FPMO227NUFA
2
Frigidaire Microwave Oven Turntable Motor Replacement
3
Tools needed: wire cutters, Phillips-head screwdriver, a new self-tapping sheet-metal screw
5
Before you begin the procedure, unplug the appliance?s power cord.
7
Remove the glass tray from the oven cavity and pull the turntable coupler straight up to remove.
9
Now tip the microwave on its right side.
10
Use the wire cutters to cut the retaining tabs securing the bottom access panel.
12
Fully detach the panel.
13
Now disconnect the power wires from the turntable motor terminals.
14
Use the Phillips-head screwdriver to unthread the mounting screw securing the motor.
15
Rotate the motor counter-clockwise to fully detach.
16
To install the new turntable motor, insert the motor shaft through the hole in the floor of the oven cavity then rotate the motor clockwise.
17
Thread the mounting screw to secure.
18
Connect the wires to the terminals.
19
Reinstall the access panel by inserting the tabs into the slots, then use the new self-tapping sheet-metal screw to secure the oppposite side of the panel.
20
Return the microwave to its upright position.
21
Align the turntable coupler on the motor shaft and push down.
22
Reposition the glass tray on the coupler.
23
Plug the power cord back in and the microwave oven should be ready for use.