Description
This video provides step-by-step repair instructions for replacing the water filter access cover on a KitchenAid Refrigerator (Model KRFF507HPS02). The most common reason for replacing this part is if it is damaged or missing.
All of the information for this video is applicable to the following brands: KitchenAid
Step-By-Step Instructions1
To replace the water filter access cover in this kitchenaid refrigerator, you will need a quarter-inch nut driver and a small flat-head screwdriver.
2
Before you begin the procedure, unplug the appliance’s power cord.
3
Open the water filter cover and remove the water filter.
4
Use the quarter-inch nut driver to unthread the two screws securing the upper cover panel.
5
Detach the panel and disconnect the led light wire harness to fully remove the panel.
6
You can now use the small flat-head screwdriver to help detach the old water filter access cover.
7
To install the new access cover, insert it through the top of the panel, align the hinge posts with the brackets, and snap the cover into place.
8
Reinstall the upper cover panel by first reconnecting the led light wire harness.
9
Align the three rear upper cover panel tabs with the housing brackets and snap the panel into position.
10
Rethread the two screws to secure.
11
Reinsert the water filter into the housing and close the cover.
12
Plug the power cord back in, and the refrigerator should be ready for use.