If your Bryant central AC is making loud noise, start with the outdoor condensing unit, where debris, worn bearings, loose panels, or a damaged fan blade are the most likely causes. A central AC making loud noise or a condenser fan making noise may simply have leaves, sticks, or other debris striking the condenser fan blade. Turn off power at the disconnect box and clear the unit before inspecting it. Next, check whether the condenser fan motor turns smoothly by hand. Grinding or rough movement usually indicates worn bearings and a failing AC fan motor. Loose grille or cabinet panels can vibrate and create an air conditioner rattling noise, while a loose or damaged condenser fan blade may wobble, contact the housing, or make the AC fan motor noisy. Less commonly, a defective contactor can make buzzing or chattering sounds and may prevent the condensing unit from cooling. Electrical testing and replacement inside the 240-volt condensing unit are beyond basic DIY work, so use a licensed technician unless qualified. Enter your Bryant model number to find the exact replacement fan motor, fan blade, or contactor for your central air conditioner.
01 - Debris Hitting Fan
Over time debris can fall into the condensing unit, causing a noise when the fan is running. Inspect the fan blade and inside the unit for any debris. Clean out the outdoor unit as needed but be sure to shut off power to the unit before attempting to clean it out.
Top Solution
02 - Bryant Central Air Conditioner Fan Motor
The fan motor has bearings that can wear out over time. When the bearings are worn out, they make loud noise. To check the bearings, try rotating the fan motor by hand. If the motor does not turn smoothly, replace it.
Enter model number to search for the required part specific to your product
If the outdoor condensing unit is noisy, the grille or one of the panels may be loose and vibrating. Check for loose panels and tighten them as needed.
Highly Likely
04 - Bryant Central Air Conditioner Fan Blade
The fan blade on the condenser fan motor might be defective or loose. To check the fan blade, wiggle the fan motor shaft. If the motor shaft is loose, tighten or replace the set screw. If the condenser fan motor is still making noise, replace the fan blade.
05 - Bryant Central Air Conditioner Condenser Fan Motor
The condenser fan motor has bearings that can wear out over time. When the bearings are worn out, they make loud noise. To check the bearings, try rotating the condenser fan motor by hand. If the motor does not turn smoothly, replace it.
The furnace control board sends a low voltage signal to the contactor. When the contactor receives the signal from the control board, it closes the circuit, sending voltage to the condensing unit components. If the contactor is defective, it will not provide voltage to the condensing unit. In addition, the contactor will make noise when it is defective. If the condensing unit is making noise but not cooling, the contactor has probably failed. To determine if the contactor is at fault, use a multimeter to test the contactor for continuity. If the contactor does not have continuity, replace it.