If your dryer drum has stopped turning or the dryer is not spinning, the most common cause is a broken drive belt — reach into the drum and turn it by hand; if it spins easily the belt is likely snapped and should be replaced. Less commonly a faulty timer can prevent the drum from turning, but that is rare and should only be tested with a multimeter after you rule out the more likely parts. Also check power first: make sure the cord is fully seated in the outlet since intermittent power can stop the motor. A clogged or wobbly blower wheel can bind the motor and stop the drum, and a seized idler pulley will let the belt slip so the drum stops turning; when replacing an idler pulley it is smart to fit a new belt at the same time. If the dryer runs, then stops and later restarts, the drive motor may be overheating and failing. Enter your model number at RepairClinic.com to find the exact replacement belt, idler pulley, blower wheel, motor or timer that fits your dryer.
01 - LG Dryer Drive Belt
The drive belt is a very long, slender belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. Over time, the belt can break from normal use. If the belt is broken, the dryer won’t turn. To quickly determine if the belt is broken, reach into the dryer and turn the drum by hand. If the drum spins very easily, the belt is likely broken. Next, inspect the belt to confirm that it is broken. If the belt is broken, replace it.
Enter model number to search for the required part specific to your product
A dryer drum that has stopped spinning unexpectedly could be caused by a faulty timer. However, this is very rarely the case. Before replacing the timer, check all the more commonly defective parts. If you determine that all of the other components are working properly, test the timer by using a multimeter and consulting the wiring diagram. If the timer is defective, replace it.
Confirm the power cord is plugged tightly into the wall receptacle. A loose plug can provide intermittent power to the dryer and cause it to stop spinning during the cycle.
Top Solution
04 - LG Dryer Blower Wheel
The blower wheel works with the drive motor to draw air into the dryer drum. Clumps of lint, socks, and small articles of clothing can escape the lint filter and get caught in the blower wheel. Since the blower wheel is usually attached to the same drive motor shaft that drives the drum belt, an obstructed blower wheel may prevent the drum from spinning. To determine if the blower wheel is working properly, remove the dryer vent and assess the strength of the air flow. If the air flow is weak, check the blower wheel for obstructions. If no obstructions are present, try rotating the blower wheel by hand. If the blower wheel... wobbles as it turns, replace it.
The dryer's idler pulley puts tension on the drive belt so the belt can rotate the drum during operation. A defective idler pulley can cause the dryer drum to stop spinning. Inspect the idler pulley and make sure it spins freely on the shaft. If the idler pulley is stuck, worn or damaged, we recommend replacing the drum drive belt in addition to replacing the idler pulley.
The drive motor turns the drum and the blower wheel to exhaust the air. If the dryer runs, stops for a while, and then starts again, this likely indicates that the motor is overheating, causing the dryer to shut off until the motor cools down. First, remove the belt from the motor and check the blower wheel to ensure that it is not obstructed. Next, with the belt removed, try rotating the drum by hand. If the drum does not rotate freely, determine what is causing the drum to bind. If the drum turns freely and the blower wheel is clear of obstructions, the drive motor might be defective. If you suspect the motor is at fault..., replace it.