Admiral Dryer Parts

Dryer drum rear felt seal kit with adhesive.

Dryer door catch kit

Dryer drum support roller

Dryer thermal fuse located on the blower housing. If the dryer overheats, the thermal fuse blows cutting off power to the motor or the heating system. When the fuse is bad the dryer won't start or will run but not heat. The thermal fuse cannot be reset. Fuses often blow due to a clogged dryer vent.

Plastic leveling leg. White approximately 1" round x 1 3/4" long

The Whirlpool Blower Wheel WP697772 is a high-quality replacement part that attaches to the drive motor shaft and blows air through the drum and out through the exhaust vent. It is important to use safety equipment and disconnect the appliance before any service or repair.

Dryer heating element wire connector kit. Wire with spade terminal & wire nut

Light Bulb

Dryer drum felt seal kit. Includes silicone rubber adhesive.

Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.

Motor pulley, 60 hertz

Dryer tri-ring retainer for drum support rollers.

Light Bulb 10 Watt small base

Thermal cut out fuse and high limit thermostat kit

White silicone adhesive caulk. Forms a heat resistant bond. Often used for gaskets, seals and burner grate feet.