KitchenAid Dryer Parts

The Whirlpool Blower Wheel WP697772 is a high-quality replacement part that attaches to the drive motor shaft and blows air through the drum and out through the exhaust vent. It is important to use safety equipment and disconnect the appliance before any service or repair.

Dryer heating element wire connector kit. Wire with spade terminal & wire nut

Light Bulb

Dryer drum felt seal kit. Includes silicone rubber adhesive.

Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.

Motor pulley, 60 hertz

This is a genuine replacement part. Whirlpool 349639 Lint Screen.

Dryer tri-ring retainer for drum support rollers.

Light Bulb 10 Watt small base

White silicone adhesive caulk. Forms a heat resistant bond. Often used for gaskets, seals and burner grate feet.

Outer grille

Universal appliance light bulb, 40A15. 40 WATT 15 AMP standard base

Heating element thermal cut-off (thermal fuse) 360 degrees and high-limit thermostat 250 degrees. The thermal fuse is a safety device designed to protect the dryer from overheating. A multimeter can be used to test the fuse. Always check the dryer venting when replacing a blown thermal fuse.

Dryer thermal fuse (or thermal limiter). This fuse is located on the exhaust duct. If the dryer overheats, the thermal fuse opens to cut off power to the dryer. The thermal fuse cannot be reset--if the thermal fuse is open, it must be replaced.

Lint screen housing foam seal