LG Tromm Dryer Parts

Drum Support Roller & Axle Set of 4 AGM75510755 set includes 4 drum rollers, the roller shaft, and mounting clips to ensure quiet operation. As the bearings wear, they self-lubricate, eliminating the need for additional grease. This set is compatible with various dryer models from LG and Kenmore.

Dryer drum drive belt. 1/4 inch wide with 4 ribs and 3 grooves. The drive belt is a very long, slender belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.

Thermostat and thermistor kit. The thermostat has reset button in center that will trip due to poor air flow such as a clogged exhaust vent.

High limit thermostat at blower housing

Dryer moisture sensor bar. If the dryer timer does not advance properly inspect the moisture sensor bars for damage which can cause the automatic drying cycle to not work properly.

Dryer thermal fuse. If the dryer overheats, the thermal fuse blows to cut off power to the dryer. If the thermal fuse has blown, the dryer won't start. The thermal fuse cannot be reset—if the fuse has blown, replace it. Thermal fuses often blow due to a clogged vent.

Dryer idler pulley and spring kit for drum drive belt

Gas dryer igniter with bracket and wire harness. This is a round spiral-style igniter. The igniter uses heat to ignite the gas in the burner assembly. If the igniter is defective, the gas will not ignite and the dryer will not heat.

Felt seal, dryer drum

Dryer drum assembly. Includes felt seals.

Dryer gas burner valve assembly. Two solenoids. When installing the new valve, transfer the orifice from the old valve to the new valve.

Dryer lint filter assembly with felt rim seal attached. Proper air flow is critical to dryer operation so the filter should be cleaned before every load. Replace the filter if it has any tears or rips in it.

Dryer leveling leg

Idler pulley wheel with bearing

Cover,lamp