Hotpoint Dryer Parts

Strike plate with strike hole

Idler arm with pulley

Selector knob, white

The Dryer Drum Belt part number WE12X10009 is a Genuine GE replacement part known for its quality and reliability. When repairing use caution. Consult the owner's manual for instructions and to verify part number.

Thermostat

Timer control knob, white with red arrow pointer, 2-3/4 inches in diameter

Push to start button, gray

This is a Genuine Replacement Part. General Electric (GENF0) WE4M160 High Limit Thermostat.

The Genuine OEM GE Appliances Idler Pulley Wheel WE12X81 maintains proper tension on the drive belt to spin the drum. It comes with a spacer and retainer clip and should be installed with the appliance disconnected from all utilities.

The GE Appliances Drum Front Slide Bearing WE3X87 is a high quality replacement part that allows the drum to rotate smoothly on the felt seal of the front panel. It is recommended to replace all bearings at once and to disconnect the appliance from utilities before installation.

The Genuine OEM GE Appliances Shutoff Valve Assembly WE14X215 is a 2 coil gas valve assembly that opens to allow gas in or closes to shutoff the gas supply to the dryer. It is recommended to disconnect the appliance from all utilities prior to installation. Compatible with various models.

Complete duct trap assembly

The GE Rear Drum Support Bearing WE3X75 is a high quality OEM part that ensures smooth and quiet rotation of the drum. It measures approximately 1 inches x 1 inches x 0.75 inches and it is recommended to disconnect the appliance before installation.

Dryer Timer. The timer controls the dryer operations. Be aware the dryer must heat properly for the timer to advance in an automatically timed cycle. Note The new replacement timer may not have the same terminals as the old one. Wires may need to be combined to fit on a single terminal.

Heat deflector plate at rear of dryer drum