York HVAC Parts

Furnace control board. The control board regulates the supply of power to the furnace components.

Gas Burner Tube

Furnace hot surface igniter kit. The igniter gets very hot and glows bright orange to light the gas burner. If the igniter is cracked or defective, the furnace won’t heat.

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Run capacitor, single,10mfd,370 volts, oval

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Limit thermostat, 150 open, 110 close

Genteq Run Capacitor 370 Volt Oval Single 7.5 MFD

Contactor with shunt, 1 pole, 30 amps, 24 volts

Flame rollout limit switch, push button to re-set

Furnace blower motor. This single-phase motor has the following specifications:

Horsepower: 1/2
Voltage: 115
Full-Load Amperage: 7.7
Hertz: 60
RPM: 1175
Speeds: 4
Rotation: Counterclockwise
Frame: 48
Enclosure: Open

Fan relay, 24v coil, 50-60hz, spst-no/nc

Furnace draft inducer motor. The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.

Upper limit switch 180° manual reset
manufacture approved alternate for
this limit switch part# S1-7990-3591

Draft inducer blower assembly. 60 Hz 1.75 Amps, 3000 RPM.The draft inducer blower draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.