Controls power flow in select Carrier Furnace, Packaged Unit/RTU, or Heat Pump. this genuine OEM contactor, part number HN53AC030, restores reliable performance with durable electrical components.
Grid is 1 inch square
Carrier Contactor HN53AC030
Manufacturer Part

Carrier Contactor HN53AC030

Genuine OEM Part # HN53AC030RC Item # 2381395
Manufacturer Part
Controls power flow in select Carrier Furnace, Packaged Unit/RTU, or Heat Pump. this genuine OEM contactor, part number HN53AC030, restores reliable performance with durable electrical components.
Grid is 1 inch square
Carrier Contactor HN53AC030
$1,167.91
Loading stock status
Loading stock status
Does this part fit my product?
Find your model number or log in to select it from your saved machines.
Controls power flow in select Carrier Furnace, Packaged Unit/RTU, or Heat Pump. this genuine OEM contactor, part number HN53AC030, restores reliable performance with durable electrical components.
Loading stock status
$1,167.91
start a live chat with Repair Clinic customer support

This part HN53AC030 is compatible with:

Product Type:
Furnace
Brands:
Carrier

Related Articles & Videos

00:45
Troubleshooting
Replace Furnace Filters - Tech Tips from Repair Clinic
02:47
Troubleshooting
Furnace Starts Then Stops — Furnace Troubleshooting
03:52
Troubleshooting
Furnace Not Heating — Furnace Troubleshooting
02:28
Troubleshooting
Furnace Blower Not Running — Furnace Troubleshooting
01:49
Troubleshooting
Furnace Noisy Or Loud — Furnace Troubleshooting
Frequently Bought with Contactor
LH680534 Flame Sensor
5303935066 Igniter
HH18HA493 Limit Switch
S1-03103010000 Control Board

Contactor Customer Reviews

Common Problems Fixed by the Contactor

Based on customer reports and repair data, this part commonly fixes these issues:

Likely

Heat pump compressor won't run

Likely

Heat pump won't turn off

Likely

Heat pump not cooling

Likely

Heat pump not heating

Likely

Heat pump won't turn on

Possible

Heat pump is noisy or loud

Possible

Furnace not heating

About the Contactor

The control board sends a low voltage signal to the contactor. When the contactor receives the signal from the control board, it closes the circuit, sending voltage to the outside unit components. If the contactor is defective, it can prevent the compressor from running. To determine if the contactor is at fault, use a multimeter to test the contactor coil for continuity. If the contactor coil does not have continuity or the contacts a on the coil look burnt, replace it.

Shop by Brands

Repair Help by Brands and Product Type