Price Match GuaranteeLennox Furnace G41UF-48C-090-2 Parts
Shop replacement repair parts for Lennox Furnace model G41UF-48C-090-2
Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.
Furnace Igniter (80 volt) *** please see related item if 120 volt igniter is needed***
White-Rodgers 21D83M-843 Direct Replacement IFC Ignition Module The ignitiov control moduleregulates the supply of power to the furnace components. Be sure to check more commonly defective parts before replacing the control board.
Condensate Trap
Capacitor single run 7.5 MFD 370 Volt oval
Switch-interlock
Blower wheel, 10 5/8 length 10 5/8 diameter, 1/2 inch bore
Main Gas Burner Assembly Four Tube
1/2HP 115Volts 60Hz 8 amp 1075 RPM's 5 Speed Open Enclosure 48Y Frame Single Phase CCW 3" Shaft. Any unused wires will need to be taped off or put on the "park" terminals on the control board. These terminals are there specifically for unused wires.
Furnace draft inducer motor. The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.
Gasket
Gasket
Manifold-gas
Hose-drain
Collar-condensate
Frequently Purchased Together For This Model
Family-owned and operated since 1912, Burke America Parts Group is the longest-running genuine appliance, HVAC, and outdoor power equipment parts solution in North America. At Repair Clinic, we're proud to be an international brand trusted by the pros as well as the DIY community.
About Repair Clinic