Shop replacement repair parts for Lennox Furnace model G43UF-48C-110-3

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Furnace igniter assembly

Condensate Trap

Limit rollout control

Capacitor single run 7.5 MFD 370 Volt oval

Switch-interlock

.85 WC Pressure Switch

Blower wheel, 10 5/8 length 10 5/8 diameter, 1/2 inch bore

1/2HP 115Volts 60Hz 8 amp 1075 RPM's 5 Speed Open Enclosure 48Y Frame Single Phase CCW 3" Shaft. Any unused wires will need to be taped off or put on the "park" terminals on the control board. These terminals are there specifically for unused wires.

Main burner

Furnace draft inducer motor. The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.

Limit Switch

Gasket

Gasket
