Shop replacement repair parts for Luxaire Furnace model PCLU-LD16N080A

Furnace control board. The control board regulates the supply of power to the furnace components.

Gas Burner Tube

Furnace hot surface igniter kit. The igniter gets very hot and glows bright orange to light the gas burner. If the igniter is cracked or defective, the furnace won’t heat.

Run capacitor, single,10mfd,370 volts, oval

Gas valve kit

Pressure switch

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

3/4HP 115Volts 60Hz 11 amp 1060 RPM's 3 Speed Open Enclosure 48Y Frame Single Phase CCW 3.5" Shaft

Limit switch,160 open,130 close

Transformer, 120 volt primary 24 volt secondary 40 va

Furnace draft inducer motor. The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.

Run capacitor 370 volt oval single 4 microfarads

Blower wheel 11"dia 8"w cw 1/2" bore

Pressure Switch, -0.75 SPNO contacts close on fall

Natural gas to LP conversion kit. *Should be installed by a certified York repairperson.