Maytag Dryer MGD4200BW1 Parts

Dryer drum support roller. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.

Dryer idler pulley assembly. Includes bracket and pulley wheel

Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.

The Whirlpool Blower Wheel WP697772 is a high-quality replacement part that attaches to the drive motor shaft and blows air through the drum and out through the exhaust vent. It is important to use safety equipment and disconnect the appliance before any service or repair.

Dryer LP conversion kit; Natural gas to LP (liquid propane). This kit includes the orifice, leak limiter, and instruction sheet.

Front panel foam seal with adhesive strip

Dryer vent testing kit is for 29" dryers with a top mounted lint screen. Use the plastic card to hang inside your dryer drum, then run the unit three times empty. If the card stays in place, the venting and dryer need to be cleaned out. Complete instructions are included.

Electric dryer power cord kit, 4 foot 30 Amp 3 wire w/closed eyelets & strain relief

Stacking kit for hybrid dryer

Four way dryer exhaust kit for side and bottom venting

Dryer rack for shoes and delicate items. Keep your items from tumbling or becoming tangled by using a dryer rack. This part fits Whirlpool Duet Premium, Vantage, and Maytag Maxima dryers.

Electric dryer power cord kit, 6 foot 30 Amp 4 wire with closed eyelets and strain relief

Drying rack - designed for Whirlpool 27 inch dryers with lint screens located inside the front door opening

Side or bottom venting kit

Drying rack for shoes and delicate items. Fits Whirlpool built 29 inch dryers with dimples 4-1/2 inches apart in dryer drum rear bulkhead.