Shop replacement repair parts for Lennox Furnace model ML195UH110XP48C-6


Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Igniter assembly (120 volt)

Ignition control board The ignition control board regulates the supply of power to the furnace components. Be sure to check more commonly defective parts before replacing the control board.

Furnace draft inducer motor. The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.

Gas valve

Capacitor single run 7.5 MFD 370 Volt oval

Rollout switch, 210f

Switch-interlock

Transformer, 120 Volt Primary 24 Volt Secondary 40 VA

Blower wheel, 10 5/8 length 10 5/8 diameter, 1/2 inch bore

Comb air gasket

Gas valve conversion kit, natural to LP. *Should be installed by a certified Carrier repairperson.

102862-02 flue coupling service kit

LP Orifice .034

Hose drain-left