Shop replacement repair parts for Lennox Furnace model ML180UH135P60D-53


Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Igniter assembly (120 volt)

Ignition control board The ignition control board regulates the supply of power to the furnace components. Be sure to check more commonly defective parts before replacing the control board.

Gas valve

Switch-interlock

Transformer, 120 Volt Primary 24 Volt Secondary 40 VA

Pressure switch -.65" wc spst 1/4" barb connection

Run capacitor, 40 MFD, 370 volts, round

Limit control, rollout, 210f

1HP 115Volts 60Hz 11 amp 1075 RPM's 4 Speed Open Enclosure 48Y Frame Single Phase CCW 3" Shaft

Inducer Motor Orifice Plate Gasket

Furnace draft inducer motor. The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.

Gas valve conversion kit, natural to LP. *Should be installed by a certified Carrier repairperson.


Gasket