Whirlpool Dryer WHD862CHC0 Parts

Dryer drum support roller. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.

The Dryer Maintenance Kit 4392067 includes drum support rollers, a multi-rib belt, an idler pulley wheel, triangle clips, and a washer for a complete maintenance overhaul. If your Whirlpool, Kenmore, or Maytag dryer is making loud noises or the drum is not turning, it may be time for replacement.

Dryer idler pulley assembly. Includes bracket and pulley wheel

Dryer drum drive belt, 93 1/2 inches long, 4 ribs 3 grooves. The drive belt is a very long, slender belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.

Dryer thermistor. This thermistor should read approximately 11.9K Ohms of resistance at 70 degrees Fahrenheit (21’ Celsius). If the thermistor is defective, it may prolong or shorten the drying time or cause a fault code. A defective thermistor is not responsible for a dryer not heating.

Dryness sensor bar

Dryer idler pulley wheel kit. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dryer will not spin

Plastic leveling leg. White approximately 1" round x 1 3/4" long

Dryer heating element wire connector kit. Wire with spade terminal & wire nut

Dryer drum felt seal kit. Includes silicone rubber adhesive.

Dryer tri-ring retainer for drum support rollers.

White Touch Up Paint

Screw, 10-24 x 1/2

Shaft for dryer drum support roller. Rear shaft with left hand threads. Part is updated so nuts may need to be replaced as well on older dryers.

Shaft for dryer drum support roller. Front shaft with right hand threads. Part is updated so nuts may need to be replaced as well on older dryers.