Kenmore Dryer 11097093800 Parts

Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.

Dryer drum drive motor with pulley

The Whirlpool Burner Igniter Kit 279311 is a high-quality replacement part that ignites gas to light the dryer burner. It replaces multiple igniters and requires safety precautions and disconnection from utilities before installation.

Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.

Dryer thermal fuse (or thermal limiter). This fuse is located on the exhaust duct. If the dryer overheats, the thermal fuse opens to cut off power to the dryer. The thermal fuse cannot be reset--if the thermal fuse is open, it must be replaced.

Drive motor kit - Note; the wiring connections may be different, comes with instructions

Adjustable dryer cycling thermostat kit L135-155. The cycling thermostat cycles the heat on and off to regulate the air temperature. If the cycling thermostat is defective, the dryer will not heat. To determine if the thermostat is defective, use a multimeter to test it for continuity.

Gas valve assembly with two & three terminal coils

Wire harness, gas valve

Harns-wire

Dryer timer

Burner-gas

This is a Genuine Replacement Part. Whirlpool (WHIRA) 279048 Thermostat - Replacement.