Kenmore Dryer 11096590830 Parts

Dryer heating element assembly. If the dryer does not heat the thermal fuse should be checked before replacing the heating element. Normally, the element will have a break in the coil if defective.

Dryer idler pulley assembly. Includes bracket and pulley wheel

Dryer lint filter. Air flow is vital to proper dryer operation. The lint filter should be cleaned before every load and replaced if damaged.

Dryer door catch kit

The Whirlpool Blower Wheel WP697772 is a high-quality replacement part that attaches to the drive motor shaft and blows air through the drum and out through the exhaust vent. It is important to use safety equipment and disconnect the appliance before any service or repair.

Dryer drum felt seal kit. Includes silicone rubber adhesive.

Dryer tri-ring retainer for drum support rollers.

Heating element thermal cut-off (thermal fuse) 360 degrees and high-limit thermostat 250 degrees. The thermal fuse is a safety device designed to protect the dryer from overheating. A multimeter can be used to test the fuse. Always check the dryer venting when replacing a blown thermal fuse.

Motor pulley

White Touch Up Paint

Screw, 10-24 x 1/2

Shaft for dryer drum support roller. Rear shaft with left hand threads. Part is updated so nuts may need to be replaced as well on older dryers.

Drive motor kit - Note; the wiring connections may be different, comes with instructions

Seal, blower cover plate. 26 in

Shaft for dryer drum support roller. Front shaft with right hand threads. Part is updated so nuts may need to be replaced as well on older dryers.