Kenmore Dryer 11077542600 Parts

The Dryer Repair & Maintenance Kit 4392065 includes rollers, a belt, and an idler pulley. It is specifically designed for 29 wide dryers built in 1965 or later. This kit addresses common issues that cause Whirlpool, Kenmore, Maytag, and KitchenAid dryers to become noisy.

Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.

Dryer door switch assembly. If the dryer does not start then the door switch could be defective. This switch also replaces the two wire switch.

The Whirlpool Burner Igniter Kit 279311 is a high-quality replacement part that ignites gas to light the dryer burner. It replaces multiple igniters and requires safety precautions and disconnection from utilities before installation.

Idler pulley for dryer drum drive belt

Dryer drum rear felt seal kit with adhesive.

Dryer door catch kit

Plastic leveling leg. White approximately 1" round x 1 3/4" long

Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.

Ring bearing kit, front of dryer drum

Dryer blower housing foam seal with adhesive backing. 26 in

Dryer front panel retainer clip. 1 clip per pack.

Door seal

Screw, 10-24 3/8

Front panel felt seal. No glue required, the seal stretches to fit. Note that seal no longer comes with the plastic retainers, reuse the old retainers.