Price Match GuaranteeWhirlpool Dryer WGD7500GW0 Parts
Shop replacement repair parts for Whirlpool Dryer model WGD7500GW0
Dryer drum support roller. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.
Dryer idler pulley assembly. Includes bracket and pulley wheel
Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.
RC Item #528948
Dryer door switch assembly. If the dryer does not start then the door switch could be defective. This switch also replaces the two wire switch.
Dryer thermistor. This thermistor should read approximately 11.9K Ohms of resistance at 70 degrees Fahrenheit (21’ Celsius). If the thermistor is defective, it may prolong or shorten the drying time or cause a fault code. A defective thermistor is not responsible for a dryer not heating.
The Whirlpool Burner Igniter Kit 279311 is a high-quality replacement part that ignites gas to light the dryer burner. It replaces multiple igniters and requires safety precautions and disconnection from utilities before installation.
Dryness sensor bar
Dryer lint filter. Air flow is vital to proper dryer operation. The lint filter should be cleaned before every load and replaced if damaged.
Dryer idler pulley wheel kit. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dryer will not spin
Dryer thermal fuse located on the blower housing. If the dryer overheats, the thermal fuse blows cutting off power to the motor or the heating system. When the fuse is bad the dryer won't start or will run but not heat. The thermal fuse cannot be reset. Fuses often blow due to a clogged dryer vent.
Plastic leveling leg. White approximately 1" round x 1 3/4" long
Dryer drum felt seal kit. Includes silicone rubber adhesive.
Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.
Dryer tri-ring retainer for drum support rollers.
Light Bulb 10 Watt small base
Frequently Purchased Together For This Model
Family-owned and operated since 1912, Burke America Parts Group is the longest-running genuine appliance, HVAC, and outdoor power equipment parts solution in North America. At Repair Clinic, we're proud to be an international brand trusted by the pros as well as the DIY community.
About Repair Clinic