Whirlpool Dryer WGD9200SQ1 Parts

Dryer idler pulley assembly. Includes bracket and pulley wheel

Dryer drum drive belt, 93 1/2 inches long, 4 ribs 3 grooves. The drive belt is a very long, slender belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.

Dryer thermistor. This thermistor should read approximately 11.9K Ohms of resistance at 70 degrees Fahrenheit (21’ Celsius). If the thermistor is defective, it may prolong or shorten the drying time or cause a fault code. A defective thermistor is not responsible for a dryer not heating.

Dryer idler pulley wheel kit. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dryer will not spin

Drive motor kit - Note; the wiring connections may be different, comes with instructions

Thermal cutoff

High limit thermostat

Panel

White Control Knob

User control board kit

Dryer door switch with wire harness and connector. This part has been discontinued by the manufacturer. However, there are service kits available for select models. These service kits include a new door switch, a new front panel, and installation instructions. See related items below.

Dryer electronic main control board. The control board regulates the dryer's main functions. Control boards are frequently misdiagnosed. Be sure to check more commonly defective parts before replacing the control board.

Door switch - **NOTE: This part is no longer available but a replacement may be available. Please contact us with your model number to determine if there is a replacement available.

Control panel

Control Board
*Per the manufacturer both the center and right user interface controls must be replaced together. Use part number off the right control to correctly identify the kit