Whirlpool Dryer WED9450WW0 Parts

The Dryer Repair & Maintenance Kit 4392065 includes rollers, a belt, and an idler pulley. It is specifically designed for 29 wide dryers built in 1965 or later. This kit addresses common issues that cause Whirlpool, Kenmore, Maytag, and KitchenAid dryers to become noisy.

Dryer idler pulley assembly. Includes bracket and pulley wheel

Dryer drum drive belt, 93 1/2 inches long, 4 ribs 3 grooves. The drive belt is a very long, slender belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.

Dryer thermistor. This thermistor should read approximately 11.9K Ohms of resistance at 70 degrees Fahrenheit (21’ Celsius). If the thermistor is defective, it may prolong or shorten the drying time or cause a fault code. A defective thermistor is not responsible for a dryer not heating.

Dryer idler pulley wheel kit. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dryer will not spin

Dryer heating element. If the dryer no longer heats then the heating element may have failed, but it is not the most common cause. The most common cause for a dryer to stop heating is a blown thermal fuse.

Thermal cut out fuse and high limit thermostat kit

Drive motor kit - Note; the wiring connections may be different, comes with instructions

Hi-limit thermostat & thermistor assembly on heating element housing, L295-80F Thermistor should read around 50 to 60Kohms at room temperature.

Console

Console

Knob

Console

Control board

Dryer door switch with wire harness and connector. This part has been discontinued by the manufacturer. However, there are service kits available for select models. These service kits include a new door switch, a new front panel, and installation instructions. See related items below.