Price Match GuaranteeWhirlpool Dryer WGD8500SR0 Parts
Shop replacement repair parts for Whirlpool Dryer model WGD8500SR0
Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.
Dryer thermistor. This thermistor should read approximately 11.9K Ohms of resistance at 70 degrees Fahrenheit (21’ Celsius). If the thermistor is defective, it may prolong or shorten the drying time or cause a fault code. A defective thermistor is not responsible for a dryer not heating.
The Whirlpool Burner Igniter Kit 279311 is a high-quality replacement part that ignites gas to light the dryer burner. It replaces multiple igniters and requires safety precautions and disconnection from utilities before installation.
Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.
Drive motor kit - Note; the wiring connections may be different, comes with instructions
Thermal cutoff
High limit thermostat
Replacement dryer gas valve & burner kit
Gas valve assembly with two & three terminal coils
Harness, main
Dryer electronic main control board. The control board regulates the dryer's main functions. Control boards are frequently misdiagnosed. Be sure to check more commonly defective parts before replacing the control board.
Frequently Purchased Together For This Model
Family-owned and operated since 1912, Burke America Parts Group is the longest-running genuine appliance, HVAC, and outdoor power equipment parts solution in North America. At Repair Clinic, we're proud to be an international brand trusted by the pros as well as the DIY community.
About Repair Clinic