Price Match Guarantee
In-stock parts ship the same day
365-Day Return Policy
Price Match GuaranteeGET PRO PRICING
Video & Articles: Appliance & Equipment RepairWhirlpool Gas Dryer Replace Dryness Control Board #W10116565
Whirlpool Gas Dryer Replace Dryness Control Board #W10116565
Skill Level
Total Parts Cost
$162.30Estimated Savings
$150.0001:32
- Description
This video provides step-by-step repair instructions for replacing the dryness control board on a Whirlpool/Kenmore gas dryer. The most common reasons for replacing the dryness control board are when the dryer takes too long or stops mid-cycle.
All of the information for this dryness control board replacement video is applicable to the following brands:
Kenmore, Whirlpool
Tools needed: flat head screwdriver, Phillips head screwdriver, putty knife
All of the information for this dryness control board replacement video is applicable to the following brands:
Kenmore, Whirlpool
Tools needed: flat head screwdriver, Phillips head screwdriver, putty knife
Step By Step Instructions
1
As with any repair, be sure you’ve unplugged the appliance before beginning.
2
Your first step is to detach the control panel. Depending on your model, you will either insert a putty knife under the panel to release the two clips or you will pull off both plastic end caps and remove the screws found underneath.
3
Now, rotate the control panel up.
4
Squeeze the mounting brackets on the old dryness control board, and pull up to remove.
5
You’re now ready to install the new dryness control board.
6
Move the old board out of the way and insert the new board into the control panel. Gently press it down into position.
7
Now, transfer the wires from the old board to the new one.
8
Rotate the control panel back down, and snap it into place.
9
If applicable, replace the screws and end caps.
10
Now, plug the appliance back in to make sure it’s functioning properly.
Description
This video provides step-by-step repair instructions for replacing the dryness control board on a Whirlpool/Kenmore gas dryer. The most common reasons for replacing the dryness control board are when the dryer takes too long or stops mid-cycle.
All of the information for this dryness control board replacement video is applicable to the following brands:
Kenmore, Whirlpool
Tools needed: flat head screwdriver, Phillips head screwdriver, putty knife
All of the information for this dryness control board replacement video is applicable to the following brands:
Kenmore, Whirlpool
Tools needed: flat head screwdriver, Phillips head screwdriver, putty knife
Step-By-Step Instructions
1
As with any repair, be sure you’ve unplugged the appliance before beginning.
2
Your first step is to detach the control panel. Depending on your model, you will either insert a putty knife under the panel to release the two clips or you will pull off both plastic end caps and remove the screws found underneath.
3
Now, rotate the control panel up.
4
Squeeze the mounting brackets on the old dryness control board, and pull up to remove.
5
You’re now ready to install the new dryness control board.
6
Move the old board out of the way and insert the new board into the control panel. Gently press it down into position.
7
Now, transfer the wires from the old board to the new one.
8
Rotate the control panel back down, and snap it into place.
9
If applicable, replace the screws and end caps.
10
Now, plug the appliance back in to make sure it’s functioning properly.
Applicable Product Model
Related Articles & Videos
Our Story
Family-owned and operated since 1912, Burke America Parts Group is the longest-running genuine appliance, HVAC, and outdoor power equipment parts solution in North America. At Repair Clinic, we're proud to be an international brand trusted by the pros as well as the DIY community.
About Repair Clinic
© 2026 RepairClinic.com