DescriptionThis video provides step-by-step instructions for replacing the spark module on a Kitchenaid double oven gas range (model #KFGD500ESS04). The most common reason for replacing the module is if the surface burners will not light.
All of the information in this module replacement video is applicable to the following brands: Maytag, Amana, Magic Chef, Whirlpool, Tappan, Estate, Kitchenaide
Step-By-Step Instructions1
Before you replace the spark module in your gas range…
2
…be sure to unplug the power cord or shut off the power supply.
3
Pull the range away from the wall so you can access the rear of the appliance.
4
Use a phillips-head screwdriver or a quarter-inch nut driver to unthread all of the screws securing the lower rear access panel.
5
Lift the panel up and out to remove.
6
Note the location of the wires connected to the spark module…then disconnect them.
7
Unthread the two mounting screws to release the old module.
8
Install the new spark module…
9
…by aligning it on the rear panel and securing it with the screws.
10
Connect the wires to the terminals.
11
Reposition the rear access panel
12
Thread and tighten the screws to secure.
13
Plug the power cord back in or restore the power supply…
14
…and the gas range should be ready for use.