DescriptionThis video provides step-by-step instructions for replacing the door handle on Electrolux dishwashers.
All of the information in this video is applicable to the following brands: Electrolux
Step-By-Step Instructions1
Electrolux Dishwasher - 24ID75SPS3A
2
Dishwasher Door Handle Replacement
3
"Heavy, Sharp, Shock, Water"
5
Be sure to turn the power to the appliance off
6
Open the dishwasher door and use a phillips-head screwdriver to unthread all of the screws holding the inner and outer door panels together
7
Note the length of each screw and its location on the inner door panel
8
Remove the top middle right screw last
10
Slide the outer door panel up to detach
11
Lift off the control panel and you can fully remove the outer panel
12
Disconnect the wire connecter from the door latch so you can rest the control panel on the floor
13
Set the outer panel handle-side down on a towel or blanket
14
"Using the phillips-head screwdriver or a number 2 square drive bit, unthread the screws securing the handle"
15
"With the screws unthreaded, remove the old handle"
16
Align the new handle on the outer door panel
17
"With the mounting plates positioned, thread the two screws into the upper holes in the handle to secure"
18
Reinstall the outer door panel by repositioning the control panel
19
"Connect the wire connector to the latch, then slide the outer panel onto the inner panel, making sure the lower tabs rest behind the hinges"
20
Replace all of the screws in the appropriate locations starting with the long top middle right screw
22
Turn the power supply back on