DescriptionThis video provides step-by-step repair instructions for replacing the right drawer slider on an LG Refrigerator (Model LFCS22520S). The most common reason for replacing this part is if the drawer will not open smoothly.
All of the information for this video is applicable to the following brands:
LG
Step-By-Step Instructions1
To replace the right drawer slider in this lg refrigerator…
2
You will need a flathead jewelers screwdriver, a flathead screwdriver and a phillips screwdriver or drill driver with a number 2 phiillips bit.
3
Fully extend out the top freezer tray by lifting the front. then pull out the ice container.
4
Next, pull and lift out the freezer tray.
5
Lift the bottom freezer drawer out from the back.
6
Use the jewlers screwdriver to depress the tab on the drawer gear and pull up to detatch it from the slide rail.
7
Pull the bar away from the other gear.
8
Loosen and remove the two phillips screws securing the freezer door and lift it up and out to remove it.
9
Now remove the three screws on the freezer rail and pull the rail from the cavity.
10
Using the flathead, release the tab holding the slider and remove it. remove the gear on the slider.
11
To install the new drawer slider…
12
Attach the gear to the slider, insert the slider into the rail and snap it into place.
13
Position the rail assembly into the freezer cavity with the back tabs first. then thread and tighten the three screws.
14
Set the freezer door by hooking the connector rails to the sliders.
15
Screw in the two phillips head screws to secure the door.
16
Insert the bar into the set gear and snap the gear on the other end into its slot within the slide rail. this can be difficult to align.
17
Place the drawer back inside the freezer.
18
Slide the tray back into the guide rails.
19
Then insert the ice container.
20
…. and the lg refrigerator should be ready for use.