Dual Run Capacitor

Compressor run capacitor, 120 volts 15 mfd.

Run Capacitor

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Flame Sensor

Furnace control board. The control board regulates the supply of power to the furnace components.

Control Board

You need Contactor HN51KC024 if you're having trouble with the compressor or fan motor on your air conditioner, furnace, heat pump, or air handler. This genuine OEM single-pole, 24-volt coil contactor has a full load amps (FLA) rating of 30 amps and a locked rotor amps (LRA) rating of 150 amps.

Contactor

The Frigidaire Oven Burner Igniter 5303935066 is a high-quality replacement part that ignites the gas to light the oven burner. It includes 2 ceramic wire connectors and replaces multiple part numbers

Igniter

Limit Switch

Dryer blower wheel. Used on 29 inch Whirlpool built models with lint filter on top. To remove the blower wheel, unscrew the blower wheel  clockwise off the motor shaft.

Blower Wheel

Flame rollout limit switch re-settable 350F

Flame Rollout Limit Switch

Relay

image

Skuttle Humidifier Water Inlet Valve Replacement #A01-0814-148

This video provides step-by-step instructions for replacing the water inlet valve on Skuttle humidifiers. The most common reasons for replacing the water inlet valve if it is burned out or clogged, causing water to not enter the humidifier or the humidifier to overflow. All of the information in this inlet valve replacement video is applicable to the following brands: Skuttle

Humidifier

Heat pump not cooling

To determine if the condenser motor is working, use a multimeter to test the incoming voltage to the motor. If the condenser fan motor is receiving the correct voltage but the motor still won’t run, inspect the capacitor to ensure that it is not at fault. If the capacitor is not bulging or leaking, replace the condenser fan motor.

Heat pump not heating

Heat pump is noisy or loud

The condenser fan motor has bearings that can wear out over time. When the bearings are worn out, they make loud noise. To check the bearings, try rotating the condenser fan motor by hand. If the motor does not turn smoothly, replace it.

Heat pump won't turn on

Heat pump fan motor does not run

Heat pump coils frosting up

Since the condenser fan motor is the component that circulates the air through unit to cool it, a defective motor could result in the coils frosting up. You can use a multimeter to test the condenser fan motor for electrical continuity, a continuous electrical path present in the motor, as well as determine if power is reaching the motor. You can also try turning the fan blade by hand. If the blade does not turn freely, it's likely the motor bearings have seized and the motor will need to be replaced.

Heat pump is frequently cycling/short cycling

A faulty condenser fan motor could cause the heat pump to short cycle. To determine if the condenser motor is working, use a multimeter to test the incoming voltage to the motor. If the condenser fan motor is receiving the correct voltage but the motor still won’t run, inspect the capacitor to ensure that it is not at fault. If the capacitor is not bulging or leaking, replace the condenser fan motor.

Heat pump circuit breaker keeps tripping

If the outdoor heat pump unit's breaker or fuses keep tripping the condenser fan motor may be to blame. To determine if the fan motor is shorted, use a multimeter to test the motor windings for a short to ground. If the fan motor blades will not turn freely, or the windings are shorted, replace the condenser fan motor.


**We’re excited to be able to offer trade professionals like you substantial volume-based discounts. Our PRO pricing levels are based on your anticipated annual parts spend with us. If your actual monthly spending trends lower than anticipated, your discount may change.

Appliance Parts, Lawn Mower Parts, Heating & Cooling Parts. 365 day returns.

Sign up for your PRO account

Create your account for exclusive discounts and benefits, like:

Your One-Stop

Shop

Join Repair Clinic Pro to unlock technician pricing, same-day shipping, dedicated support, and exclusive benefits tailored for repair professionals.

PRO users get exclusive discounts and benefits, like:

This account is not eligible, please contact your customer service representative for any questions.

Unlock technician pricing and exclusive Pro benefits at Repair Clinic. Join free today.

Repair Clinic Pro

Repair Clinic Pro | Discounts & Benefits for Technicians

Your discounted pricing and other Pro benefits are now available.

Thank You for joining Repair Clinic Pro!

Return parts & products within 365 days of placing your order.

Adhesives & Sealants Parts

Appliance Adhesive & Sealant Parts

Air Filters

Air Filters for Home

Appliance Cleaners

Appliance Cleaners for Sale

Dishrack Parts

Dishrack Replacement Parts

Dryer Vents

Dryer Venting Parts

Equipment Covers

OPE, HVAC & Appliance Part Covers

Fuel Treatments

Fuel System Treatments

Hardware & Fasteners

Hardware and Fasteners Parts

Kitchen Appliance Accessories

Kitchen Accessories Parts

Washer & Dryer Accessories

Dryer and Washer Accessories

Light Bulb Parts

Light Bulb Fixture Parts

Oil & Lubricants

Oil and Lubricant Parts

Paint & Supplies

Touch Up Paint & Supplies

Power Cords Parts

Power Cord Repair Parts

Safety Equipment Parts

Safety Equipment Spare Parts

Testing Equipment Parts

Testing Appliance, OPE & HVAC Parts

Specialty Tools Parts

Specialty Tool Parts for Sale

Vacuum Attachments

Vacuum Attachment Parts

Water Filters & System Parts

Water Filter System Parts

Water Treatment Parts

Water Treatment System Parts

Wire & Connector Parts

OPE, HVAC & Appliance Wire & Connector Parts

Lawn Care Supplies

Yard Care Supplies

Heating & Cooling Supplies

HVAC Supplies

CHANNELLOCK Tools Parts

CHANNELLOCK Replacement Tools

Gas Cans & Nozzles

Nozzles & Gas Cans for Sale

Maintenance Repair Kits

Maintenance Appliance Repair Kits

OPE cleaners & Filters Parts

Outdoor Power Equipment Cleaners & Filters

Power Tools Parts

Power Tool Replacement Parts

Appliances

Refrigerator

Dryer

Range/Stove/Oven

Washing Machine

Dishwasher

Washer/Dryer Combo

Microwave

Freezer

Oven/Microwave Combo

Trash Compactor

Ice Machine

Range Vent Hood

Vacuum Cleaner

Garbage Disposer

Dehumidifier

Hot Water Dispenser

Heating & Cooling

Furnace

Packaged Unit/RTU

Heat Pump

Central Air Conditioner

Air Conditioner

Air Handler

Condenser Fan Motor

Motor

This free troubleshooting video shows quick maintenance tips for taking care of your Gree PTAC Unit. If you're unable to find the information you need on our website, we suggest that you use a search online to find a reliable online repair forum. It's likely that your question has already been answered there. We also recommend contacting your product's manufacturer or calling a local repair technician. And don't forget to like and comment on this video, and subscribe to our channel!

PTAC Unit Maintenance Tips

This video provides step-by-step repair instructions for replacing the transformer on a Skuttle humidifier. The most common reason for replacing the transformer is when it is blown. All of the information for this humidifier transformer replacement video is applicable to the following brands: Skuttle

Skuttle Humidifier Transformer Replacement #000-0814-008

This video provides step-by-step repair instructions for replacing the water evaporator pad on a Skuttle humidifier. The most common reason for replacing the water evaporator pad is when the water isn't draining properly. All of the information for this water evaporator pad replacement video is applicable to the following brands: Skuttle

Skuttle Humidifier Replace Water Evaporator Pad #A04-1725-052

This video provides step-by-step instructions for replacing the humidistat in Skuttle humidifiers. The most common reason for replacing the humidistat is if water does not enter the humidifier, even at the humidistat’s highest setting. All of the information in this humidistat replacement video is applicable to the following brands: Skuttle

Skuttle Humidifier Humidistat Replacement #SK0-0055-001

This video provides step-by-step repair instructions for replacing the inline filter on a Skuttle humidifier. The most common reason for replacing the inline filter is when the filter is clogged, causing the humidifier not to work properly. All of the information for this inline filter replacement video is applicable to the following brands: Skuttle

Skuttle Humidifier Inline Filter Replacement #000-1319-051

This video provides step-by-step instructions for replacing the wick in Skuttle humidifiers. The most common reason for replacing the wick is if water isn’t being evenly distributed in the evaporator tray and the wick hasn’t simply become dislodged. All of the information in this wick replacement video is applicable to the following brands: Skuttle

Skuttle Humidifier Wick Replacement #000-1317-091

This video provides step-by-step instructions for replacing the water distribution tray in Skuttle humidifiers. The most common reason for replacing the water distribution tray is if it is clogged or cracked, causing the humidifier to not drain properly. It might also simply be out of place. All of the information in this water distribution tray replacement video is applicable to the following brands: Skuttle

Skuttle Humidifier Water Distribution Tray #000-0602-055

Condenser-Fan-Motor

ICP 1185076 Packaged Unit/RTU Condenser Fan Motor | Repair Clinic

ICP Condenser Fan Motor 1185076

This part 1185076 is compatible with:

Related Articles & Videos

Condenser Fan Motor Customer Reviews

Common Problems Fixed by the Condenser Fan Motor