DescriptionThis video provides step-by-step repair instructions for replacing the washer timer dial on a Whirlpool electric washer/dryer combo (model #WET4027EW0). The most common reason for replacing this part is if it is damaged or missing.
This replacement video is applicable to the following brands:
Whirlpool, Maytag, Kitchenaid
Don't forget to like and comment on this video and subscribe to our channel!
Step-By-Step Instructions1
Before you replace the washer timer dial on your washer / dryer combo…
2
…be sure to unplug the power cord or shut off the power supply.
3
Use a 5/16th inch socket or nut driver to unthread the three screws securing the control panel assembly.
4
Detach the panel assembly.
5
Make sure the washer timer knob is pushed in.
6
Now use a small flat-head screwdriver to pry out the retaining pin so you can remove the knob.
7
You can now pull the old timer dial forward to detach.
8
Install the new timer dial…
9
…by aligning it on the shaft until it is flush against the control panel.
10
Replace the timer knob.
11
Push the retaining pin in to secure.
12
Realign the control panel assembly.
13
Rethread the three screws on top.
14
Plug the power cord back in or restore the power supply…
15
…and your washer/dryer combo should be ready for use.