HVAC Parts

Door latch

Blower motor 208-230v1ph 830rpm 1sp

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Countertop bracket

Furnace draft inducer motor. The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.

Aluminum anode rod 3/4" NPT X 3" X 39-1/8

Control fan timer

Limit switch

Limit switch, manual reset

1/4 HP 208-230Volts 60Hertz 1.7Amps 825RPM Closed Enclosure 48Y Frame Single Phase CCW Rotation 2.25" Shaft

Furnace blower wheel. 12" X 11.93" 1/2" Bore. The blower wheel blows air out of the furnace and through the house. The blower wheel is attached to the blower motor shaft with a set screw. If the set screw is loose, the blower wheel will wobble on the motor shaft and be noisy as it turns.

Dual round run capacitor 35+5 mfd 370 volt

Door handle stud screw

Hot surface furnace igniter kit.
If the electrical connnector on your old part is different than the new igniter, it can be cut off and spliced onto the new igniter wires using the provided wire nuts.

Furnace control board. The control board regulates the supply of power to the furnace components. Be sure to check more commonly defective parts before replacing the control board.